
Mainline ProHub dyno
Precision without compromise. One of only a handful of these systems in the UK and Europe. Most of our tuning is done here, in the safest environment there is, then proven on the road, at the drag strip and on track.
Not chasing numbers
Dyno tuning isn't about a big figure on a sheet. It's about reliable, usable performance. We work on high-performance cars and R35 GT-Rs, from stock-engine fast road setups to 1000+ whp track and drag cars, with a focus on drivability, control and, above all, long-term reliability.
The dyno is where we do the majority of the work, safely and precisely. Then every tune is tested on the road, at the drag strip and on track in real conditions. Dyno first, real world second, never one without the other.

Repeatable, safe, accurate
No tyres in the way
The dyno bolts straight to the hubs. No wheel slip, no tyre deformation and no tyre blowing up at extreme power.
No straps to let go
The car is bolted to the dyno, not strapped down on rollers. Nothing to snap, nothing to shift.
Repeatable results
Run after run reads the same, so a change in the numbers is a real change in the tune, not noise.
Built-in weather station
Every run is automatically corrected for the conditions on the day, so results compare fairly whatever the weather.
Precise load control
We can hold the engine at any rpm and load and creep up on fuelling and timing in a controlled way, without putting the engine at risk.
Real power at the wheels
Before an R35 GT-R goes on, we convert it to rear-wheel drive, mechanically and electronically. You see the true power going through the wheels.
The true dyno for performance cars at this level.
Rated beyond 3000hp. Your car won't trouble it.

Mainline ProHub 3000
A serious piece of professional equipment, built for high-powered street and race cars. It measures real torque at the hubs, so the numbers you see are the numbers your car makes.
- Measured, not guessed: power is calculated from torque measured by precision load cells on each hub, not estimated from roller inertia.
- No tyres, no slip: billet steel adapters bolt straight to the hubs, removing tyre pressure, wheel spin and strap variables.
- Steady-state tuning: holds the car at any rpm and load, so every cell of the map is tuned properly, not guessed between pulls.
- Built-in weather station with automatic correction to international standards, so results compare fairly day to day.
- Full data logging: twin wideband lambda, twin 7-bar boost sensors and CAN logging, live on screen while we tune.
- Left-to-right torque balancing, plus drag-strip run simulation for drag cars.
On the hubs





Hire our hub dyno
£250 + VAT per hour. Bring your car and your own tuner. We set the car up on the dyno and run it for you, so all your tuner has to do is tune.
Arrive with your car ready to run in rear-wheel drive (RWD). If it's all-wheel drive and not ready for the dyno, we can remove the front prop shaft on our ramp for an additional cost.
